Calibration Support Messages
These messages may appear in a pop-up window during the calibration phase after a program is started. In some cases they prompt for operator action; in other cases they notify the operator of an abnormal condition.
This message appears whenever a board is needed from the operator. It appears when MOUNT is selected from the main menu bar, or for every board on a non...
This message appears when purging without a time limit. Purge will continue until a button is clicked. Click DONE to stop the purge and continue operatio...
This message appears during calibration before touch down of a dispense needle on a machine with an electrical touch pad. Attach ground clip and click CO...
This message appears during calibration after touch down of a dispense needle on a machine with an electrical touch pad. Remove ground clip; then click C...
This message appears after a dispense needle has been purged during calibration when no automatic needle cleaner is configured. Wipe the needle clean; the...
This message appears during calibration before touch down of an etch head on a machine with an electrical touch pad. Lock the probe up, attach ground clip...
This message appears during calibration after touch down of an etch head on a machine with an electrical touch pad. Release the probe, remove ground clip; ...
This message appears during calibration when a drill motor is to be calibrated, or when calibration dots are placed on the drill pad rather than on paper. I...
This message appears if an attempt is made to run a program for which no heads have been defined (possibly, a program converted from pick-and-place data a...
This message appears if any error occurs when reading a program from the data base. The Program Name appears in the message if the error does not preclude...